Mitzi Triton

Check out this Good Looking, Super Tough, Aftermarket Molded Snorkel Kit for your Mitzi Triton and turn your Triton into a "Tough Truck"

This Aftermarket Snorkel set will fit the Mitsubishi Triton, ML & MN models from 2006 through to 2015 and is compatible with the following engines:-
1) 4M41-T 3.2 ltr Diesel Motor
2) 4D56 DI-D 2.5 ltr Diesel Motor
3) 6G74 3.5 ltr Petrol Motor

Installing a Snorkel on your 4WD will raise the air intake and improve overall performance as well as protecting your engine from dirt and water damage

These are made from indestructible, flexible, Roto Molded Polyethylene (LLDPE) that will stand up to the toughest of conditions without breaking

A snorkel relocates your engines air intake point from a relatively low and vulnerable position under the bonnet to a much higher and safer location where a constant source of cool, clean air is available.

And because a snorkel is forced through the air as the vehicle travels, it creates what is known as ram air effect. This has often been found to provide a welcome increase in engine performance.

Comes in a durable, textured semi gloss black finish that will not scratch off and is also UV Resistant

The Full Kit comes with Templates and all hardware, (Screws, Pins, Cerclips and Washers) as well as an "Water Overflow Bottle" for a right hand side fit

Fitting instructions are provided, but if you are not familiar with fitting a Snorkel, it is advised that you get it professionally installed

We are the Queensland Agents for Kut Snake "Tough Truck" molded wheel arch Flare Kits and Accessories

Mitzi Triton