• Facebook Clean
  • Instagram Clean

© 2023 by PANDORA'S DREAM. Proudly created with Wix.com

Check out this Good Looking, Super Tough, Aftermarket Molded T7 Snorkel Kit for your Ford Ranger  Series , 3.2 Diesel and turn your Ranger into a "Tough Truck" (Will not fit the Ranger PX Series)

Installing a T7 Snorkel on your 4WD will raise the air intake and improve overall performance as well as protecting your engine from dirt and water damage

These are made from indestructible, flexible, Roto Molded Polyethylene (LLDPE) that will stand up to the toughest of conditions without breaking

A snorkel relocates your engines air intake point from a relatively low and vulnerable position under the bonnet to a much higher and safer location where a constant source of cool, clean air is available.

And because a snorkel is forced through the air as the vehicle travels, it creates what is known as ram air effect. This has often been found to provide a welcome increase in engine performance.

Comes in a durable, textured semi gloss black finish that will not scratch off and is also UV Resistant, also has a cutout for fitting a indicator light (not included)

The Full Kit comes with Templates and all hardware, (Screws, Pins, Cerclips and Washers) for a right hand side fit

Fitting instructions are provided, but if you are not familiar with fitting a Snorkel, it is advised that you get it professionally installed

We are the Queesland Agents for Kut Snake "Tough Truck" molded wheel arch Flare Kits and Accessories

Ford Ranger MK2 3.2TD

AU$250Price